Water Heating Specials

Water Heating Specials

Option 1:

135L Low Pressure H.W.C Replacement.

Supply and install 1 x new 135L Low Pressure hot water cylinder in your existing cylinder location. West Auckland only

Includes:

  • Removal (from site) and disposal of old H.W.C
  • Supply and installation of new Rheem 135l H.W.C. Re-using existing valves and piping. Some piping alterations included to fit new H.W.C and seismic restraints included.

Price $1,260 plus GST ($1,449.00 including GST)

Note: This does not include:

  • Any electrical work that may be required.
  • Supply and installation of a safe tray to meet the new building code requirements. (+$250+gst  if possible to run drain from cylinder position)
  • Cupboard door or opening must be big enough to remove existing cylinder and fit new one or an additional charge may apply.
  • Supply or installation of new reducing valve if required. (+$200+gst)
  • Supply and installation of new relief valve if required. (+$120+gst)

Option 2:

180L Mains Pressure Replacement or Upgrade.

Supply and install 1 x new 180l Rheem Mains Pressure hot water cylinder in your existing cylinders location. West Auckland only

Includes:

  • Removal (from site) and disposal of old H.W.C
  • Sealing of any old roof penetration
  • Supply and installation of 180l Mains Pressure H.W.C and all necessary valves
  • Installation complying with current plumbing codes and manufactures recommendations.
  • Seismic restraints.
  • Converting low to mains pressure tapware 1 x bathroom only

Price $1,975 plus GST ($2,271.25 including GST)

Note: This does not include:

  • Any electrical work that may be required.
  • Supply and installation of a safe tray to meet the new building code requirements. (+$250+gst  if possible to run drain from cylinder position)
  • Cupboard door or opening must be big enough to remove existing cylinder and fit new one or an additional charge may apply.

Option 3:

Instant Gas Water Heater Install.

Supply and install 1 x Rinnai A26 instant gas water heater (external) on twin L.P.G gas bottles piped back to your existing plumbing system. Water heater must be located above gas bottles and maximum of 5metres each hot/cold water and gas piping allowed for this price to apply.  West Auckland only

Includes:

  • Removal (from site) and disposal of old H.W.C
  • Sealing of any roof penetration
  • Concrete pavers for gas bottles and organize delivery if required
  • Supply of auto change regulator and chains for gas bottles
  • Supply and installation of 1 x Rinnai A26 Instant gas water heater to suit requirements
  • Installation complying with current plumbing codes and manufactures recommendations.
  • Converting low to mains pressure tapware 1 x bathroom only
  • All our external piping is tidy/straight and done in Copper to last in the N.Z sun. (If you are looking at another company’s quote/cost ask if they do the same?)

Price $2,475 plus GST ($2,846.25 including GST)

Note: This does not include:

  • Any electrical work that will be required. (1 x external power point beside water heater)
  • Cupboard door opening must be big enough to remove existing cylinder or an additional charge may apply.
  • There are certain locations that this type of heater can and cannot go; there may not be a suitable spot on your house so a free site visit will be provided to make sure that this is a good option for your specific installation. Ideally a clear external wall space near the kitchen/bathroom at least 1000mm long between any openings (windows/doors) and access to below the house.

For installation on Natural gas (Mains) the above price will include up to 10m of gas piping back to the meter or existing gas supply, additional piping will come at an extra cost.

There are also new and retrofit Solar options available on our Solar page!

We can provide any electrical work required on a charge up basis through a registered electrician we work with and provide an estimate on electrical cost and confirmed plumbing cost for you before we start the job.

We specialize in hot water cylinder upgrade work (Electric, Gas and Solar) and are very proud of the many fine installations we have done in west Auckland over the many years I have been in business.

The difference you have with us and some of the bigger plumbing company’s / cylinder change company’s is that:

  • I will be on site at least once and be in complete control of how the job is done.
  • There are no hidden costs or cutting of corners and as you can see from our feedback on our Testimonials page very happy customers.

Paul McCallum (Certifying Plumber/Gasfitter 20+years)

Picture6 Picture6a